Click to return to home page
www.ptfeparts.com

PFA
Perfluoroalkoxy Copolymer Resin
Transfer Molding Applications

PCTFE
PFA Lined Hose Coupling
For Enhanced
Chemical Resistance

Inert to nearly all industrial chemicals & solvents.



Call us to discuss
your Transfer Molding application.

(800) 752-7082

  
PCTFE - Molded & CNC machined parts.

PFA: Click for Data Sheet



TeflonŽ PFA 350 retains properties after service at temperatures up to 260°C (500°F).  It maintains useful properties as low as -196°C (-320°F)

Click here for typical material property data.

PFA 350 is a clear general-purpose fluoropolymer resin, with properties similar to PTFE.  It is typically used for chemical linings in pipes, tubing, valves and fittings.

Please note that APT does not injection mold PFA.

Material characteristics include the following:

  • Low flow rate suitable for transfer molding
  • Chemically inert to most industrial chemicals & solvents
  • Good creep resistance at upper service temperature
  • Increased flex life over PFA Grade 340
  • Enhanced resistance to stress cracking over other grades
  • Exceptionally low dielectric constant & dissipation factor
  • Resists ignition and does not promote flame spread

    • Typical Material Properties - See above link for additional information:
    • Tensile Strength, Ultimate:  ~4000 psi
    • Tensile Strength, Yield:  ~2180 psi
    • Tensile Creep Modulus, 1 hour:  39,2000 psi
    • Elongation at break:  300%
    • Hardness, Shore D:  55
    Note: The property data offered represents average values obtained on laboratory test samples. Values listed are high limits. Properties may vary based upon processing technique and temperature. Data should be used only as a guide in selecting the appropriate compound. Actual performance will be affected by processing methods as well as end use service conditions.

    Applied Plastics Technology, Inc.
    45 Broad Common Road
    PO Box 45
    Bristol, RI 02809  USA
    (800) 752-7082
    (401) 253-0200, Fax: (401) 253-0474
    email: info@ptfeparts.com
    About Us | Processing | Fabrication | Stock Shapes | Materials | Customer Service | Teflon® Resin Info | Home
    •  Site Map  •  © 2003  Applied Plastics Technology, Inc.  •  Terms of Use  •  Privacy Policy  •